carpet strip tack::My country had a little diaster when compare with another country that have earhquake or tornado , but why we destroyed ourselves carpet strip tack

carpet strip tack::My country had a little diaster when compare with another country that have earhquake or tornado , but why we destroyed ourselves.
Wide hole in the floor.
The same is true with doorway transition plates that edged your carpeting or tile.
The removal of old walls will leave even bigger holes in the floor.
The following information can help you repair your floor holes so that smooth modern flow coated flooring can be applied.
After removing floor tiles, tack strips, doorplates, walls etc.
Your floors will need to be cleaned so that your holes can be filled with a permanent bond.
If all that you need is the holes filled the preparation need only apply to those areas.
This will mean that your holes will be made level again but you will be able to see each of them unless covered with another material.
If you will be using an epoxy or urethane coating over the top you should prepare the entire floor before filling your holes.
There will be some surface tension holding the epoxy together and when it hardens in about 12 hours you will need to use a 4in.
Grinder with a masonry wheel.
Note if you are going to coat your floor with epoxy you can do this while the whole epoxy is still wet.
This can save quite a bit of time during your grinding phase.
Once you have ground off the edges of your pours just sweep up the epoxy dust for your next coat.
You may want to repeat or touch up some pours if needed.
Durall industrial flooring supplies kits of materials customized to owner specification and delivered directly to the job site.
He uses a saddle transition with a rounded edge and a flat top.
He also adds a door sweep to keep out cold air.
He sets the hardwood underneath the transition with liquid nails, tightly fits the grooves of the hardwood and then nails the surface down.
He then sands the wood smooth, sets the transition and uses silicon to seal the gap between the floor and the transition.